Indesit KD3G2S(W)/IR Návod k použití stáhnout pdf (Strana 6)

Take particular care handling the spark

plug wires and the thermocouple pipes.

 Replace all the parts, following the steps

described above in the reverse order.

b)Minimum regulation of the gas oven burner with

thermostat:

 light the burner as described in the paragraph

the oven knob of the instruction booklet.

 turn the knob to Max for about 10 minutes and

then turn the knob to the Min setting;

 remove the knob;

 regulate the screw positioned outside the

thermostat pin until the flame is small but steady.

 in the case of liquid gas, the regulation screw

must be screwed in to the bottom.

 check that the burner does not turn off when you

turn the knob from Max to Min and and when

you open and close the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

 remove the screw and then slide out the grill

burner V (see Figure);

 unscrew the grill burner nozzle using the special

socket spanner for the nozzles (see Figure) or

better still a 7mm socket spanner; replace the

nozzle with a nozzle for the new type of gas (see

table 1).

Important

On completion of the operation, replace the old

rating sticker with one indicating the new type of gas

used. This sticker is available from our Service

Centres.

Note

Should the pressure of the gas used be different (or

vary) from the recommended pressure, it is

necessary to fit a suitable pressure regulator onto

the inlet pipe in compliance with current National

Regulations relative to regulators for channelled

gas.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Žádné komentáře

Indesit KD3G2S(W)/IR Návod k použití Strana 6