Indesit KP 648 MS (X)/DK (T) Návod k použití stáhnout pdf (Strana 31)

INSTALLATION

ELECTRICAL CONNECTION

Those ovens equipped with a three-pole power supply cable

are designed to operate with an alternating current with the

voltage and frequency indicated on the data plate (located

on the appliance) and in the instruction booklet. The wire for

earthing the appliance is yellow-green in colour.

Fitting on a power supply cable

Opening the terminal board:

• Using a screwdriver, prise on the side tabs of the terminal

board cover;

• Pull open the cover of the terminal board.

To install the cable, proceed as follows:

• Remove the wire clamp screw and the three contact

screws L-N-

• Fasten the wires beneath the screwheads using the fol-

lowing colour scheme: Blue (N) Brown (L) Yellow-Green

• Secure the supply cable in place with the clamp and close

the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load indi-

cated on the data plate. When connecting the cable directly

to the mains, install an omnipolar circuit-breaker with a mini-

mum contact opening of 3 mm between the appliance and

the mains. The omnipolar circuit breaker should be sized

according to the load and should comply with current regula-

tions (the earth wire should not be interrupted by the circuit

breaker).

The supply cable must be in such a position that no part of it

can reach a temperature of 50°C above room temperature.

Before connecting to the power supply, make sure that:

• The electrical safety of this appliance can only be guar-

anteed if the cooker is correctly and efficiently earthed,

in compliance with regulations on electrical safety. Always

ensure that the earthing is efficient; if you have any doubts

call in a qualified technician to check the system. The

manufacturer denies all responsibility for damage result-

ing from a system which has not been earthed.

• Before plugging the appliance into the mains, check that

the specifications indicated on the date plate (on the ap-

pliance and/or packaging) correspond to those of the elec-

trical and gas mains of your home.

• Check that the electrical capacity of the system and sock-

ets will support the maximum power of the appliance, as

indicated on the data plate. If in doubt, consult a qualified

technical engineer.

• If the socket and appliance plug are not compatible, have

the socket replaced with a suitable model by a qualified

technical engineer. The latter, in particular, will also have

to ensure that the cross section of the socket cables are

suitable for the power absorbed by the appliance. The use

of adapters, multiple sockets and/or extensions, is not

recommended. If their use cannot be avoided, remember

to use only single or multiple adapters and extensions

which comply with current safety regulations. In these

cases, never exceed the maximum current capacity indi-

cated on the single adapter or extension and the maxi-

mum power indicated on the multiple adapter. The plug

and socket must be easily accessible.

1 2 ... 26 27 28 29 30 31 32 33

Komentáře k této Příručce

Žádné komentáře

Indesit KP 648 MS (X)/DK (T) Návod k použití Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Indesit KP 648 MS (X)/DK (T)