Indesit KD3G11(X)/G Návod k použití stáhnout pdf (Strana 6)

flame is small but steady.

N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.

• check that the flame does not turn off when you turn the tap quickly from high to low.

c) Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Important

On completion of the operation, replace the old rating sticker with one indicating the new type of gas used.

This sticker is available from our Service Centres.

Note

Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to

fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relative to

“regulators for channelled gas”.

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Electrical connection

Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which

conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing

the back panel of the cooker itself with a screwdriver.

N.B.: the following installation procedure must be carried out by a qualified electrician. The electrical installation must

comply with the IEE Regulations, Building & local By-Lays.

For the installation of the feeding cable carry out the following operations:

1 Open the terminal board by inserting a screwdriver into the side tabs of the

cover. Use the screwdriver as a lever by pushing it down to open the cover (see

diagram).

2 Loosen the cable clamp screw and remove it, using a screwdriver as a lever

(see figure).

3 Remove the wire contact screws L-N-

, then fasten the wires under the screw

heads, respecting the colour code: Black/Blue (N), Red/Brown (L) and Bare Wire/

Yellow-Green (

l Once the connections have been made, tighten all the terminal screws fully.

l Fasten the supply cable in place with the clamp and close the cover of the

terminal board.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Žádné komentáře

Indesit KD3G11(X)/G Návod k použití Strana 6